Binaural Beats Explained: What They Are and How They Work

The Beat Is Not in the Sound

Put a microphone at either ear while a binaural beat is playing and it records a steady tone with no beat in it. That is the whole phenomenon in one sentence, and it is what separates a binaural beat from every other kind of beating you can hear.

The setup is simple. One ear receives a tone at one frequency, the other receives a tone a few hertz away — 400 Hz on the left and 410 Hz on the right, say — and the listener reports a pulsation at 10 Hz, the difference between them. Each ear’s signal is a pure tone of constant amplitude. Neither contains a 10 Hz anything. The pulsation is produced by the listener’s auditory system when it compares the two, which makes this a psychoacoustic effect rather than an acoustic one.

Compare It With an Ordinary Beat

Play 400 Hz and 410 Hz through the same loudspeaker and you also hear a 10 Hz beating, but for a different reason. The two waves superpose in the air, alternately reinforcing and cancelling, and the result is a physical amplitude modulation at the difference frequency. A microphone in the room records it. This is an ordinary acoustic beat, and it needs no listener.

In the binaural case there is no superposition, because the tones never share a medium. What varies is the relative phase of the two signals arriving at the brainstem: if the frequencies differ by 10 Hz, the phase relationship between them rotates through a full cycle ten times a second. The circuitry that compares timing between the ears — the superior olivary complex, whose normal job is working out where a sound came from — is sensitive to that interaural phase difference, and a continuously rotating phase is what the listener experiences as a beat.

Three stacked traces sharing one time axis spanning 100 milliseconds. The top trace is the left ear carrier, a sine wave of constant amplitude completing eight cycles. The middle trace is the right ear carrier, also of constant amplitude, completing nine cycles. The two start in phase at zero milliseconds, are out of phase at 50 milliseconds, and return to phase at 100 milliseconds. The bottom trace is the perceived beat: a single slow rise and fall, highest where the carriers are in phase and lowest where they oppose. An arrow spanning the full width is labelled one beat period, 100 milliseconds. Each carrier is annotated as having a steady level, and the perceived beat is annotated as not being present in either signal. In phase Out of phase In phase One beat period, 100 ms 0 25 50 75 100 Time (milliseconds) Left ear carrier Right ear carrier Perceived beat Steady level Steady level Not in either signal
The two carriers and the beat they produce. The example in the text is 400 Hz against 410 Hz; the traces are drawn at 80 and 90 Hz so that individual cycles are visible, and the 10 Hz difference and the 100 ms beat period are to scale. The third trace is the percept, not a signal — nothing in the air oscillates at 10 Hz.

The figure is worth reading twice. The top two traces are the signals; neither changes level. The bottom trace is the percept, peaking where the two carriers align and fading where they oppose. Only the first two exist in the air.

Where the Effect Works and Where It Fades

Because the mechanism depends on neural timing, it has frequency limits, and these have been measured. Licklider, Webster and Hedlun fixed one tone and varied the other until the beating disappeared. The largest usable frequency difference was found near a 400 Hz carrier, at around 35 Hz; beats were still audible with carriers above 1,000 Hz, but only with careful attention and only when the frequency difference was small. The practical consequences are that carriers in the low hundreds of hertz give the most robust effect, and that a large frequency difference and a high carrier do not combine.

The same paper explains a long-standing disagreement in the literature about the upper carrier limit: the limit depends on how large a frequency difference you are testing with, so two experiments using different differences will report different ceilings without either being wrong.

Headphones Are Not Optional

Everything above depends on each ear receiving only its own tone. Over a loudspeaker that condition fails immediately: both tones reach both ears, they superpose in the air on the way, and what the listener hears is an ordinary acoustic beat. The mechanism has been bypassed, not engaged.

So binaural beats require headphones or sealed earphones, and the relevant property is channel separation. Closed-back headphones and in-ear monitors that seal the canal keep the channels apart well. Open-back headphones leak between channels, which weakens but does not generally destroy the effect. Bone conduction headphones cannot work for this at all, because they drive both cochleae through the skull and there is no separation left to speak of. Reports that binaural beats "do not work" most often turn out to be reports of listening through speakers.

What the Beat Sounds Like at Different Rates

How the beat is perceived as the frequency difference grows. The EEG band names are conventional labels for frequency ranges and are listed here only because they are commonly used — see the next section on what they do not imply.
Frequency differenceConventional band nameHow it is perceived
Below 4 HzDeltaA slow waxing and waning; individual pulses countable
4-8 HzThetaA flutter; the pulses begin to run together
8-14 HzAlphaDiscrete pulses give way to a continuous roughness
14-30 HzBetaA buzzing texture on the carrier tones
Above about 35 Hz—Beyond the measured limit even at the best carrier; the percept goes

Two cautions about this table. The perceptual descriptions are the standard account of what happens as a modulation rate rises through the range where the ear stops resolving individual events, not a result from a controlled listening study. And the band names in the middle column are frequency ranges borrowed from electroencephalography. They are included because listeners encounter them constantly in product descriptions, not because a beat at 10 Hz has been shown to do whatever an alpha rhythm does.

What the Evidence Does Not Support

The acoustic phenomenon is not in doubt: two slightly different frequencies, one per ear, produce a perceived beat, and that has been reproducible since the nineteenth century. The claims that need separating from it are the cognitive and neural ones.

The central claim in the marketing is brainwave entrainment — the idea that listening to a 10 Hz beat drives cortical activity to 10 Hz, putting the listener into a corresponding state. A 2023 systematic review examined the empirical basis for that hypothesis and found fourteen studies meeting its inclusion criteria: five reported results consistent with entrainment, eight reported results contradicting it, one was mixed, and the studies were highly heterogeneous in method. That is not a weak positive finding; it is an inconsistent literature, and it does not support the claim as usually stated.

On cognitive and affective outcomes more broadly, a meta-analysis by Garcia-Argibay, Santed and Reales examined binaural beats in relation to cognition, anxiety and pain perception, and the field it summarises is characterised by small samples and varied designs. The reasonable position for a reader is that the evidence base is thin and contested, and that any product promising a specific mental state from a specific beat frequency is claiming considerably more than has been shown.

One further point of honesty: sitting still with headphones on, doing nothing else, is itself a relaxing activity. Any study that compares binaural beats against no audio at all is measuring that too.

Generating Them Accurately

Producing binaural beats in a browser takes two oscillators, one panned hard left and one hard right, each generating a sine wave. The controls on this site are a carrier frequency and a beat frequency, and the carrier is the left-ear tone rather than a centre point between the two: the right ear gets the carrier plus the beat. At a carrier of 200 Hz and a beat of 6 Hz the ears therefore receive 200 and 206 Hz, not 197 and 203, so raising the beat frequency moves one tone up rather than splitting both away from a centre. Accuracy matters more here than elsewhere in audio work, because the perceived beat is a difference: an error of one hertz in either oscillator is an error of one hertz in the thing the listener is there for. Oscillator frequencies in the Web Audio API are specified as floating-point values, so the precision available is far finer than the requirement.

The noise bed and the low default level are comfort settings rather than claims: a quiet layer of broadband noise under the carriers gives the ear something other than two sustained sine tones to sit with, and it lets the carriers stay lower in level while the beat remains audible. Set the volume to the lowest level at which the beat is audible; there is nothing to gain from more.

References

Frequently Asked Questions

Do binaural beats work without headphones?

No. The effect requires each ear to receive only its own tone. Through speakers both tones reach both ears and superpose in the air, which produces an ordinary acoustic beat instead — a real sound a microphone can record, but not the binaural phenomenon. Bone conduction headphones also cannot produce it, because they drive both cochleae through the skull.

What frequencies produce the strongest binaural beat?

Measurements by Licklider, Webster and Hedlun put the largest usable frequency difference near a 400 Hz carrier, at about 35 Hz. Beats remain audible with carriers above 1,000 Hz, but only with careful attention and only when the frequency difference is small. Carriers in the low hundreds of hertz are the robust choice.

Can binaural beats change your brainwave state?

The evidence does not support it as usually claimed. A 2023 systematic review of the entrainment hypothesis found fourteen eligible studies: five consistent with entrainment, eight contradicting it, and one mixed, across highly heterogeneous methods. That is an inconsistent literature rather than a weak positive one.

Why mix binaural beats with background noise?

A quiet layer of broadband noise under the carriers lets them sit lower in level while the beat stays perceptible, and it gives the ear something other than two sustained sine tones. That is a comfort preference rather than a measured effect, so treat it as one: if the tones alone are pleasant enough, the noise bed adds nothing.

WhiteNoise.top

WhiteNoise.top builds free browser-based noise generators, mixers and breathing timers. Our articles explain the acoustics behind those tools and cite published research where it exists.